Parts for 2002-2008 Dodge Ram 1500 NP241D Manual Shift Transfer Cases

Bearings

top_page
photo
QU50502 Front Output Rear Bearing Made in U.S.A.

Please refer to QU50502 page for more details and ordering information.

Yes
* Kits made up of multiple items may not show an inventory in-stock status but are almost always in stock!
photo
QU50114 1 Piece Mainshaft Front Pilot Bearing and Cup

Please refer to QU50114 page for more details and ordering information.

Yes
* Kits made up of multiple items may not show an inventory in-stock status but are almost always in stock!

Drive Chains

top_page
photo
QU50266 2002-2004.5 Dodge NP241D Transfer Case Drive Chain 2002-2004 NP241D 1¼" wide RAM 1500 QU50266 is an 84 link 1-1/4" wide Genuine Morse HY-VO™ USA made original equipment transfer case drive chain that fits 2002 to 2004 Dodge New Process NP241D Second Generation Transfer Cases in Dodge Ram 1500 4x4 trucks
Yes
* Kits made up of multiple items may not show an inventory in-stock status but are almost always in stock!
photo
QU50288 2004.5-up Dodge NP241D Transfer Case Drive Chain 2004.5 and newer NP241D 1¼" wide RAM 1500 QU50266 is a 98 link 1-1/4" wide Genuine Morse HY-VO™ USA made original equipment transfer case drive chain that fits 2004.5 and newer Dodge New Process NP241D Second Generation Transfer Cases in Dodge Ram 1500 4x4 trucks
Yes
* Kits made up of multiple items may not show an inventory in-stock status but are almost always in stock!

Shift Parts

top_page
photo
QU11025 2002-2008 Dodge Ram 1500 NP241D Transfer Case Shift Lever Bushing Is a genuine original equipment part that fits 2002-2008 Dodge Ram 1500 4x4s with New Process NP241D manual shift transfer cases
Out of Stock
* Kits made up of multiple items may not show an inventory in-stock status but are almost always in stock!

Small Parts

top_page
photo
QU11039 Planetary Lock or Thrust Plate for New Process Chain Drive Transfer Cases Is a genuine original equipment part that fits most New Process and New Venture chain drive transfer cases with low range. The Tanged Lock Plate is the heavy 1/8" thick cast iron thrust plate that is located between the outer plastic Planetary Thrust Washer and the Planetary Snap Ring
Yes
* Kits made up of multiple items may not show an inventory in-stock status but are almost always in stock!
photo
QU11138 Transfer Case to Case and Rear Extension Housing to Rear Bearing Retainer Bolt With factory applied Threadlocker. Most 241 series Transfer Cases will use eight of these genuine New Process Gear original equipment QU11138 Bolts to attach the front and rear case halves to each other and four to secure your rear extension housing to the rear bearing support
Yes
* Kits made up of multiple items may not show an inventory in-stock status but are almost always in stock!

Snap Rings

top_page
photo
QU10893 Input Shaft to Bearing Snap Ring Fits in the snap ring slot machined in your input shaft and it is installed after your push the shaft through the Input Bearing. QU10893 genuine NPG Input Bearing to Input Shaft Snap Ring
Yes
* Kits made up of multiple items may not show an inventory in-stock status but are almost always in stock!