Parts for New Process NP203 Full Time Transfer Cases in 1974-1979 Ford 4x4s

Case Parts

top_page
photo

QU10915 NP203 Front Output, Rear Bearing Retainer For all 1974-1979 Ford NP203 full time transfer cases

Drive Chains and Sprockets

top_page
photo

QU50005 NP203 Chain Sprocket 2nd design, 2" wide

Gaskets

top_page
photo

TK10680 Torque King® Poppet Plug Gasket Fits all NP203 Full Time Transfer Cases. Used under the Differential Lock Poppet Plug. Precision cut from the correct thickness crush resistant material to provide accurate poppet spring tension

photo

QU50039 Cork PTO Gasket fits NP203 Transfer Case Range Sections and all other transmissions and transfer cases with standard 6 bolt PTO openings

photo

QU50178 Paper PTO Gasket fits NP203 Transfer Case Range Sections and all other transmissions and transfer cases with standard 6 bolt PTO openings.

Shift Forks, Rails, Small Shift Parts, Etc.

top_page
photo

QU50252 Poppet Spring For the Differential Lock Shift Rail on all 1974-1979 Ford New Process NP203 Full Time Transfer Cases

photo

QU50349 Poppet Ball for The Differential Lock Shift Rail on all 1974-1979 Ford New Process NP203 Full Time Transfer Cases

photo

QU20132 NP205 Shift Poppet Plug For the Differential Lock Shift Rail on all 1974-1979 Ford New Process NP203 Full Time Transfer Cases

Small Parts

top_page
photo

QU50294 NP203 Small Parts Kit For years 1973-1979 includes these essential, but hard to find small parts: Range Countershaft Needle Roller Bearings, Rear Output Shaft Pilot Needle Roller Bearings, Sprocket Carrier Needle Roller Bearings, Lubricating Thrust Washer, Four Snap Rings, Poppet Spring, Poppet Ball, and Shift Fork Roll Pin

photo

QK2036 Nut and Washer Set Replaces worn or damaged NP203 rear output Nut and Washer for non-CV applications. Kit includes Hardened Washer and Special Self-Locking Nut

photo

QK2040 Front Output Lock Nut and Washer Set For 1974-1977 Ford NP203 transfer cases with 30 Spline Front Output Shafts

Thrust Washers

top_page
photo

QU20033 NP203 Countershaft Thrust Washer Is a genuine New Process part for all New Process NP203 full time transfer cases in 1974-1979 4x4 F-150, F-250 trucks. Also fits 1978-1979 Bronco and 1979 F-350