Parts for GM New Process NP243 Transfer Case in Chevy, GMC Trucks

Bushings

top_page
photo

QU10130 Small Bore Genuine New Process Rear Output Bushing is a genuine original equipment bushing for General Motors New Process NP243 Transfer Cases in full size 4x4's from 1980-up with a slip yoke that is approximately 1-7/8" in diameter.

More Info

Yes
* Kits made up of multiple items may not show an inventory in-stock status but are almost always in stock!

Chains

top_page
photo

QU50071 GM NP241C Transfer Case Drive Chain 1-1/4" wide Genuine Morse HY-VO? USA made original equipment transfer case drive chain. Made in U.S.A.

Yes
* Kits made up of multiple items may not show an inventory in-stock status but are almost always in stock!

Gaskets

top_page
photo

TK30052 6 Bolt Round Transfer Case Adapter Gasket fits between your GM 4x4 transmission and 32 spline input transfer case. TK30052 is the current original equipment service part for GM 32 spline input NP243 mounted behind automatic transmissions and NV4500 5 speed manual transmissions. Made in U.S.A.

Yes
* Kits made up of multiple items may not show an inventory in-stock status but are almost always in stock!

Seals

top_page
photo

QU50514 Transfer Case Output Seal is a genuine NPG original equipment Seal with triple seal lip construction. The protective outer lip deflects road splash and debris and the inner 2 lips seal oil in. QU50514 fits most chain drive New Process Transfer Cases with fixed type 1-7/8" hub diameter, front or rear output yokes with in Chevy and GMC 4x4s. Made in U.S.A.

Yes
* Kits made up of multiple items may not show an inventory in-stock status but are almost always in stock!

Small Parts and Small Parts Kits

top_page
photo

QU50918 Basic Small Parts Kit for GM New Venture NP243C Transfer Cases. More Info

Yes
* Kits made up of multiple items may not show an inventory in-stock status but are almost always in stock!