QU42120U Used 16 Spline Dana 60 Loaded Open Differential Case for 4.10 and faster gear ratio Dana 60 axles in 1975 and older trucks.
Depending upon the year, a cut gasket or RTV sealant was used by Dana-Spicer to seal the differential cover. Early, thin gauge covers with embossed flanges are made for use with a cut gasket. Later thick gauge covers with flat flanges are designed for sealing with RTV or if you desire, you can use a combination of a cut gasket with thin films of RTV. We stock both genuine Dana Gaskets and Ultra Gray RTV Sealant which has high adhesion and excellent resistance to synthetic lubricants.
Knowing how to do the job right the first time is half the battle. With our detailed, easy to read, and well illustrated technical publications, you get accurate service procedures, torque specifications, and tool recommendations.
TM4400 Pinion and Differential Bearing Service On Dana-Spicer Monobeam Axles covers step by step in text and photos the differential service procedures, specifications, and tools needed to replace differential and pinion bearings in Dana Spicer front or rear drive axles.
Proper lubrication and replacing damaged or worn small parts is often the difference between a first class, long-term repair and a short lived nightmare. In this section are the small parts and accessory items that do not neatly fit under our other parts headings.
Sometimes, you just need one or two small parts to get back on the road. Between the small parts listed in this section and many others listed under part specific headings elsewhere on the page, we probably have that pesky little part you have to have but just can't find anywhere else.
Dan the Gear Man® Safety Note: Ring Gear Bolts are designed for a single use. They must be replaced after they are removed!
Please refer to QU40086 page for more details and ordering information.
International used 1-3/4" spindles for all axle code 14016 and 14017 Dana 60 rear axles in 1966-1975 3/4 ton trucks. These parts are not the same as the IHC made RA15 rear axle that was an optional axle for 1966-1975 era trucks.
QU10576 Tabbed Spindle Nut Lock Washer for 1966-1975 IHC 3/4 ton trucks with Dana 60 Rear Axles.
Having the right tool for the job makes the work easier and faster, plus the correct tool will usually minimize the chances of wrecking parts. We offer many special tools made specifically for the Dana 60 or Dana 61 front axle in your 1966-1975 IHC 3/4 ton.
QT1032 Case Spreader Is used to relieve the differential bearing preload making it easy to safely remove and install your front differential without damaging expensive critical parts.
The Dana 60 full floating rear axles used in 1966-1975 IHC 3/4 ton trucks have the same wheel bearings and seals.