QT1138 Dana 60, Dana 70 Inner Axle Seal Installer Tool

photo

QT1138 1958-1982 Dana 70 Closed Knuckle Adjustable Depth Inner Axle Shaft Seal Installer for Diana 70 closed knuckle front drive axles in vintage Dodge and International 4x4 trucks. QT1138 is specifically made to install Dana Spicer genuine original equipment QU40382 Inner Axle Shaft Oil Seals quickly and easily without damaging the seal. QT1138 works on 1958-1978 Dodge Dana 70 and 1961-1982 International Dana 70 closed knuckle front axles. This Adjustable Depth Installer is used in conjunction with QT1133 Press Screw and QT1130 Thrust Plate to make successful installation of your tight fitting inner axles seal simple, Easy, and straight forward. The seal fits the face-grooved Installer like a glove, so it will not cock or crush during installation. Precision CNC machined right here in Roberts, Montana U.S.A.

Click HERE for Tool Features

 

QT1138
Front Axle Shaft Oil Seal Installer for Dana 60, Dana 70
$54.97
* Kits made up of multiple items may not show an inventory in-stock status but are almost always in stock!

tech note

Dan the Gear Man® Tech Note 1:
Successfully installing a axle shaft seal without the correct Seal Installer is difficult. Makeshift methods don't usually get the job done due to the restricted area you need to work in, and the amount of compression needed to be applied to the seal. Due to the way we have to make the Tool, your Seal Installer and Seal MUST match. QT1138 will only work with original equipment design, NOK manufactured seals such as our QU40382. Seals manufactured by other seal manufacturers WILL NOT WORK WITH THIS INSTALLER!!!! We do not manufacture installers for this application to fit any other competitive seal designs such as National or NAK.

tech note

Dan the Gear Man® Tech Note 2:
QT1138 Installer is an Adjustable Depth Installer that allows you to offset the seal to a deeper depth to miss a groove or other damage on the axle shaft. However, YOU MUST be careful you do not set the seal TOO DEEP which may place the seal beyond the axle shaft seal surface!

tech note

Dan the Gear Man® Tech Note 3:
Once the axle is disassembled, the old seals can be easily removed with our TS4862 Seal Remover Tool Set or other suitable tool such as a length of sturdy pipe that will fit inside the axle tube. You will also need to clean the inside of the axle tube to remove dirt and crud that could get pushed into your new seal during reassembly.

Application

Dodge:
1958-1974 W300 (May also be found in some specially equipped W200 4x4s with Dana 70 closed knuckle front axles)
1974-1978 W600 with Dana 70 Closed Knuckle Axle (For the W600, the Dana 70 was the base axle, an optional Rockwell FDS75 axle was also available)

International:
1961-1962 C-130 
1963-1964 C-1300 D-1300 1965
1966 1300A 
1967 1300B 
1968 1300C 
1969-1970 1300D  
1971-19731310 
1974-1975 200 (With Optional Dana 70 Closed Knuckle Front Axle) 
1962-1978 1600 Loadstar 4x4
1979 S1600