QT1812 Outer Pinion Bearing Cup Installer is used to install many of the Bearing Cups used in Chevy, Dodge, Ford, GMC, and Jeep SUV's, 1/2, 3/4 and 1 ton trucks from 1942 to current. QT1812 fits our QU50400 (Dana Axle Outer Pinion), QU50539 (Inner or Outer Axle Pinion), QU50533 (Dana Axle Outer Pinion), and QU50574 (Dana 20, 21, 300 Transfer Cases) bearing cups. Precision CNC machined solid steel tool is drilled to accept any driver handle with a 5/8" tip. Made in U.S.A. Be sure to read Tech Notes below!
Dan the Gear Man® Tech Note 1:
Using a Bearing Cup Installer not only saves time, but, more importantly, also allows you to install the bearing cup without damaging either the cup or bearing bore. Bearing Cup Installers are the key to damage free bearing cup installation. With one, you can completely seat those bearing cups without nicks or dings. Using the proper Cup Installer and Handle completely eliminates one of the most common causes of premature bearing failure, namely installation with punches or other makeshift tools.
Dan the Gear Man® Tech Note 3:
As of May 1, 2011, QT1812 was redesigned to fit more applications. The current QT1812 replaces our previous QT1812 and QT1815 tools. The new QT1812 Installer is made to install all these Timken® Taper Bearing Cup numbers: 02820, 25821, HM88510, and HM88610. QT1812 Installers sold before that date only work on 02820, 25821, and HM88510.
Transfer Case Rear Output Shaft Front Bearing Applications
Ford: Bronco 1966-1976 Dana 20 Transfer Case
Ford: F100 with 3 speed transmission and Dana 20 Transfer Case 1966-1976
Ford: F100 with 4 speed transmission and single speed Dana 21 Transfer Case
IHC: All Scout with Dana 20 Transfer Case
Jeep: 1972-1973 All
Jeep: 1974-1979 All models with manual transmissions
Dana Axle Models 25, 27, 30, 44, 50, 53
Jeep: 1942 to Present
Outer Pinion Bearing Cup Applications
Dana Axle: Models 60, 61 and 70 1954-present. These axle models are found in many heavy 1/2 ton, 3/4 ton, and 1 ton front and rear axles used by Chevy/GMC, Dodge, Ford, IHC, and Jeep. The Dana 70 was also used by Dodge and International as a front axle on 1-1/2 ton trucks.
Chevy/GMC: 1500HD & 2500 with 14 bolt 9.5" Ring Gear 1981-2002
Front Inner Pinion Bearing Applications
Dodge: 1500 1994-2001
Ford: F250 with 4600 lb. Dana Model 50 Twin Traction Beam IFS Axle 1980-1988
Ford: F250 All 1989-1998
Ford: F350 with Dana Model 50 Twin Traction Beam IFS Axle 1980-1984
Ford: Bronco, F-150 Model 44 IFS Axle 1992.5-1996
Ford: F250, F350 Single Rear Wheel Dana Model 50 Monobeam Axle 1999-2004
Jeep: All CJ, TJ, WJ, XJ, YJ, ZJ with Model 30 Front Axles 1972-up