QU40086 Ring Gear Bolt for Dana 60 and Dana 70 Axles

photo

QU40086 Dana 60, Dana 70 Genuine Dana-Spicer Grade 9 Ring Gear Bolt has locking teeth under the hex head to prevent loosening under any load conditions. QU40086 is an exact fit, genuine Dana-Spicer replacement part for most Dana 60, Dana 61, Dana 70, and Dana 70HD axles from the mid-1980's on. This bolt, which has a serrated inner face, resists loosening better than smooth faced, aftermarket or first design QU40522 Dana original equipment bolts. QU40086 also works great for retrofitting older axles in place of the original bolt as long as you use torque spec given in below.

Dan The Gear Man® Safety Note: Ring Gear Bolts are designed for a single use. They must be replaced after they are removed!

QU40086
Ring Bolt
Yes
* Kits made up of multiple items may not show an inventory in-stock status but are almost always in stock!

tech note

The Dana factory recommended torque for QU40086 Bolt is 125-135 lb.-ft.. Tighten Bolts in a Crisscross pattern.

tech note

Apply Threadlocker to the Bolt threads before installation.

tech note

Matching Parts for QU40086 Dana 60/70 Ring Gear Bolt:
QU40367 Dana 60/70 Cover Gasket
S82194 RTV Sealant
QU40097 Dana 60/70 Pinion Seal for most 1960's-1990's axles
QT2005 Dana 60 Inner Pinion Bearing Installer
QT1003 Dana 70 Inner Pinion Bearing Installer
QT1812 Outer Pinion Bearing Cup Installer
QT1805 Dana 60, Dana 70U Inner Bearing Cup Installer
QT1098 Dana 60, Dana 70 Differential Master Bearings
QT1099 Dana 70HD Differential Master Bearings- Discontinued
QT1158 Dana 60, Dana 70 Differential Bearing Installer
QT1032 Differential Case Spreader

Application

APPLICATIONS ARE INCOMPLETE, ADDITIONAL DATA WILL BE ADDED AS TIME PERMITS

Chevrolet:
1990-up Vans with Model 70

Dodge:
Model 60 Front: 1994-2002
Model 60, 70 Rear 1989-2002

Ford:
Model 60 Front 1993-2004
Model 70, 70HD Rear 1980-1985 F350, 1981-2018 Van

GMC:

Jeep: