TKA2157/TKA2158/TKA2159 Torque King® Premium Ball Bearing Kits for NP205 Transfer Cases feature high quality, long-lasting North American Made Ball Bearings. Each Kit includes two TK50105 Output Bearings, plus the correct Input Bearing for your specific NP205 application.All Bearings include a Snap Ring factory installed in the outer race groove. Made in USA except input bearing for GM 10, spline, GM 27 spline, or Dodge 23 spline direct mount transfer cases may be made in either USA or Canada
The Front and Rear Output Ball Bearings on all NP205 Transfer Cases are the same. There are 3 different Input Shaft Ball Bearings used on the various NP205 models. Remote Mount (Divorced) Transfer Cases use the same Deep Groove Type Ball Bearings Bearings as the output shafts. Deep Groove Bearings can handle both combined radial/thrust loads for power transfer plus additional thrust loads from driveshaft articulation. All direct mount NP205 models were designed to use Maximum Capacity Input Bearings which can handle high input torque loads and speeds. Max Capacity Bearings have shallow groove races so TK50119 MUST NOT be used for output or remote input applications even though it has the same ID/OD as TK50105.
The Outside Diameter of the Snap Rings included with our Torque King Ball Bearings is slightly larger than the OD of the original snap rings used by New Process. Consequently, these Rings have greater contact with the case and are much less prone to wear into the case or slip down into the oversize lead-in taper found on some of the case bearing bores.
1969-1993 New Process NP205 Transfer Cases