QU40268 Front Wheel Bearing Retainer for 1974-1979 Dodge Dana 44 Front Axles fits all 1974-1979 Dodge Ramcharger, W100, W150, W200, W250, and Plymouth Traildusters with live spindle Dana 44 front axles. We have a limited supply of new and good used and reconditioned QU40268R Retainers that we have checked for wear, cleaned up, and applied a black oxide finish for corrosion protection. QU40268R Retainers do NOT include the wheel seal. Made in U.S.A.

See Applications, Shopping Cart & Related Main Page Links Further Down This Page
Use Your Browser Back Arrow to Return to Previous Page

Dan the Gear Man® Tech Note 1:
Loose wheel bearings are a common problem with the 1974-1979 Dodge Dana 44 Live Spindle front axle. Since the bearings are not adjustable, it only takes about 0.005" combined total wear on your wheel bearings, wheel hub, bearing retainer, and/or steering knuckle to have loose wheel bearings. I worked on a lot of these Dodge trucks in the 1970's and 1980's and I found worn hubs on probably close to 50% of the vehicles with loose wheel bearings. If both the inner and outer wheel bearings are not a tight press fit on your old Hub, you MUST replace it with a new hub!

Dan the Gear Man® Tech Note 2:
Theoretically, the front bearing retainers are not a "wear" part that will require replacement. However, if the outer bearing cup wears into the inner face of the retainer beyond 0.001-0.002" it will need to be replaced. To check the fit of your retainer, first clean and verify the inside of the steering knuckle is not worn in any way (if it is, you need a new knuckle). Remove the brake shield. Install a new QU50205 Wheel Bearing Set in the knuckle (do not pack the bearings or use old bearings for this step!). Bolt the retainer to the knuckle and torque the bolts to 30 lb.-ft.. At a point midway between the bolt holes, try to insert a 0.004" feeler gauge between the retainer and knuckle. If you have the 0.004" or greater clearance, life is good and you can move on. Less than 0.004" clearance means you have problems. Either the knuckle and/or retainer are worn!

Dan the Gear Man® Tech Note 3:
Matching Parts for QU40268 Bearing Retainer:
QU50267 5 Bolt Wheel Hub
QU11035 8 Bolt Hub and Rotor Assembly
QU50206 Outer Wheel Seal
QU50205 Wheel Bearing Set
QU40074 Inner Wheel Seal
QK4732 Axle Shaft Nut and Washer
QT1008 Axle Shaft Nut Socket

QU40268R
Reconditioned Front Wheel Bearing Retainer for Dodge 4x4s
QU40268
New Front Wheel Bearing Retainer for Dodge 4x4s
Very Limited Supply!!

APPLICATIONS:

UNDER CONSTRUCTION!