QU40854 7290 Series 16 Spline Greaseable Slip Yoke with Press On Seal is made to fit Dodge 7290 series front or rear driveshafts that have had the original slip stub replaced by an aftermarket 1-3/8" diameter, 16 spline slip stub such as our QU40740 Slip Stub for front CV driveshafts. This Yoke WILL NOT fit Dodge original equipment 1.25" 16 spline stubs!!!!!

See Applications, Shopping Cart & Related Main Page Links Further Down This Page
Use Your Browser Back Arrow to Return to Previous Page

Dan the Gear Man Tech® Note:
QU40854 Slip Yoke takes 7290 Series u-joints which are retained by internal c-clips that fit against the inside of the yoke ears. Width between the yoke ears is 2-5/8". U-Joint cup diameter is 1-1/8". Standard Duty U-Joint is QU40775. Heavy Duty U-Joint part number is TK40722.

Dan the Gear Man Tech® Note 2:
QU40845 typically mates to 16 spline slip stubs that have 1.375" outside diameter partial length splines (spline length is usually 2.25" to 3"). The yoke measures 7-3/8" from the center of the u-joint hole to the end of the spline.

Dan the Gear Man Tech® Note 3:
Install the press-on seal BEFORE trying to install the Slip Yoke on the splined slip stub.

Dan the Gear Man Tech® Note 4:
The Slip Yoke and weld Yoke at the opposite end of the tube MUST be in phase (See TM3000 Driveshaft Manual).

QU40854
Special Size Slip Yoke for Dodge
$72.97 or Save $3 by purchasing Online for only $69.97


Check Out Now

APPLICATIONS:

Dodge trucks with modified driveshafts